The MB-22 E-Z Polishing Powder is a superior wet polishing powder that delivers a high shine and dazzling gleam. Formulated for terrazzo and calcite-based stones, this polishing powder won’t etch surfaces with splatter. General Directions Different stones require different polishing techniques. In general, you would need to: Prepare the surface. Hone it to the highest clarity possible. Apply proper masking materials to areas of the surface that can be damaged by splatters. Below are the specific directions for buffing terrazzo floors and countertops: Floors: Target an area of approximately 10 sq. ft. In the middle of the target area, sprinkle approximately 2 oz. of product in a circular pattern slightly smaller than the diameter of the floor machine. Using a hog’s hair pad, position the floor machine with water on top of the powder. The machine cannot exceed 175 RPM for best results and needs at least 1.5 HP. Release 5 seconds of water and swiftly swing the machine back and forth over the targeted area to evenly spread the slurry. (Note: keep the slurry thick; not too wet.) Polish slowly with a spiral motion moving from one end of the targeted area to the other and back. Continue polishing for 3-4 minutes. Then check the surface with a squeegee. You should have a high polish at this point. Next release just enough fresh water onto your target area to make vacuuming the used slurry easy. Then clean with a neutral cleaner such as MB-1 Floor Amore One Step Cleaner or MB-15 Stone Glow. Now repeat this process on next section. Countertops: Target an area approximately 4 sq. ft. On the targeted surface, sprinkle 1 tablespoon of product in a circular pattern slightly smaller than the polishing pad you are using. Spray some water on the powder and over the rest of the targeted area. Set the speed of the right-angle grinder/polisher (variable speed is a MUST) to the slowest speed. Using a hog’s hair pad, move the machine over the targeted area slowly, applying steady pressure. Check the surface for results after approximately 2 minutes. If you have a high polish, semi-flush the section and pull the slurry down to next section and repeat. Coverage: Depending on the type of stone, expect coverage of approximately 125 – 200 sq ft per pound.
